Consisting of the stress balanced gear pump, DC motor, multi-functional manifold, valves, tank, ect., this electrical power unit is intended to operate materials managing equipment. The decreasing motion is achived from the solenoid valve with the decreasing speed controlled by an adjustable needle valve. The left and appropriate functions are equipped by using a dual pilot operated verify valve and cross-over relief valves.
Remark: Please seek advice from our income engineer to the diverse pump displacement, motor energy or tank capability.
1. This electrical power unit is of S3 duty cycle, i.e.,non-continuous operation,30 seconds on and 270 seconds off.
2. Clean all the hydraulic elements concerned just before set up of the power unit.
3. Viscosity in the hydraulic oil shoud be 15~46 cst, which need to also be clean and free of charge of impurities.N46 hydraulic oil is recommended.
4. This electrical power unit should be mounted horizontal.
5. Check the oil level in the tank immediately after the 1st get started of your electrical power unit.
six. Oil modifying is needed following the first one hundred operation hrs, afterwards the moment just about every 3000 hrs.
SNOW PLOW Energy UNIT