Capacity
All power take-offs are particularly designed for traveling pto gearbox hydraulic pumps to SAE J744C series ‘B’ specification with splined insight shaft and either two-bolt or four-bolt fixing. The utmost power which may be transmitted can be 22 KW (29.5 bhp) per 1000 rev/min engine speed; this compatible a torque of 209 Nm (155 Ibf.ft. – 21.33 kgm.).For PRM1000 the clutched power take-off provides pump rotation exactly like the engine, where as the direct drive power take-off for the PRM500 and PRM750 will give opposite rotation. Capacity to the pump is not affected by the normal use of the gearbox for propulsion duties. All ancillary power circuits powered by PRM power take-offs ought to be designed in accordance with the recommendations of the hydraulic products manufacturer, and really should be correctly safeguarded against overloading.
Installation
PRM power take-off units fit on the rear face of the main gearcase and are driven by the input shaft; consequently they could be operated at all times whilst the engine is running, The energy take-off replaces the finish cover which is generally fitted and performs the features of the finish cover by sealing the gearbox against lack of oil and correctly positions the insight shaft back bearing. Power take-off systems provide the link between the gearbox and the hydraulic pump.

Direct Drive Power Take-Off
On the PRM500 and PRM 750 the direct drive power take-off is certainly driven directly from the gearbox input shaft; consequently it’ll operate at all times when the engine is running, and since there is no clutch for disengagement of the hydraulic pump, provision must be manufactured in the auxiliary hydraulics circuits for pressure by-move to the reservoir when power to the pump is not required. A couple of 1:1 ratio gears, providing adequate offset between the gearbox result shaft and the centreline of the power take-off to make sure there is sufficient clearance between the hydraulic pump and propeller shaft coupling.

Specifications
Ever-Power PTO Shaft
Series 6
1-3/8 inch 6-spline tractor end yoke and a 1-3/8 inch 6-spline FD2 clutch on the implement end
FD2 clutch
Collapsed length: 47 in.
Prolonged length: 60 in.
62 HP at 540 RPM
98 HP at 1000 RPM
FD2 clutch attaches with one bolt that matches a groove on input shaft of rotary mower