Power UNITS FOR LIFT TABLE one
Basic Description
This energy unit is intended solely for the modest lift table,Consisting of large strain gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This electrical power unit continues to be broadly used inside the marketplace of logistic units for example minifork lift, scissors lift and ariel working platforms. The lower-ing movement is controlled by the solenoid valve using the speed managed by the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE two
Standard Description
This power unit is developed exclusively for the medium lift table, Consisting of hugely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing motion is actived from the solenoid valve and the speed managed by the adjustable needle valve. When the lift rises to a large positoin, however the power supply is cut, the decreasing movement is managed through the manual override perform.
Power UNITS FOR LIFT TABLE 3
General Description
This energy unit is designed exclusively for the massive lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived through the solenoid valve plus the pace managed by a pressure compensated flow management valve.
Energy UNITS FOR LIFT TABLE four
Common Description
This power unit is intended solely for your substantial lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived from the solenoid valve along with the pace managed through the adjustable needle valve. When the lift rises to a higher positoin, but the energy provide is cut, the lowering motion is managed from the manual override perform.
Unique Notes
1. This electrical power unit is of S3 duty cycle, which may only operate intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean each of the hydraulic parts concerned ahead of installation of the electrical power unit.
3. Viscosity from the oil shoud be 15~46 cst,which really should also be clean and no cost of impurities.N46 hydraulic oil is recommended.
four. Oil changing is needed after the preliminary a hundred operation hours,afterwards after each and every 3000 hrs.
five. The electrical power unit proven is built to be mounted vertically.