Material Handling Electrical power UNIT two
This electrical power unit options power up gravity down circuit. Activate the get started solenoid to start the motor to lift the machine. The lowing motion is activated through the solenoid valve using the lowering speed controlled from the stress compensated movement control valve. Merchandise of this series is usually broadly utilized in the industry of logistic gadgets for instance fork lift, mini lift table, and so forth.
1. The duty of this power unit is S3,i.e.,thirty seconds on and 270 senconds off.
two. Clean all of the hydraulic components concerned before mounting the electrical power unit.
three. Viscosity from the hydraulic oil shoud be 15~46 cst,which must also be clean and cost-free of impurities, N46 hydraulic oil is advised .
four. Oil altering is required following the original 100 operation hours,afterwards when each and every 3000 hrs.
5. The electrical power unit should be mounted horizontally.
Material Managing Energy UNIT 1
This energy unit is created to the fork lift field, consisting of extremely effective gear pump, DC motor, manual raise and reduced valve, tank, ect. The up and down movement are managed from the lever of the guide release valve, that is equipped with an electrical switch to activate the motor. The lowing speed is managed from the strain compensated movement control valve.
1. The duty of this electrical power unit is S3, i.e. thirty seconds on and 270 senconds off.
2. Clean all of the hydraulic elements concerned before set up of the power unit.
3. Viscosity in the hydraulic oil shoud be 15~46 cst, which should really also be clean and no cost of impurities, N46 hydraulic oil is advisable .
four. Oil changing is required after the first a hundred operation hrs, afterwards after just about every 3000 hours.
5. The energy unit shown is created to be mounted horizontally.