“H” CLASS Refuse Drag Chains can be used for conveying sawdust,wooden chips, pulp, garbage, tankage, ashes, and other abrasive spend through either wooden or steel troughs. Due to its huge, wide opening region, “H” CLASS Refuse Drag Chain provides sizeable carrying capacity when Auto Chain managed at moderate speeds.
Leading face of every barrel is flat, providing a broad area to push material along the trough and also to keep the chaim from riding over the top of the material. The rounded internal part of the barrel can be carefully shaped to make excellent sprocket get in touch with. Sidebars are reinforced with wearing sneakers which provide both
additional wearing surface area and stiffening for the hyperlink. A vertical member on each sidebar assures added hyperlink rigidity and defends the pin from damage.
“H”CLASS Refuse Drag Chain comes in EVRT-POWER Promal or Duramal with a tensile strength range of 36,400 to 52,000 pounds. This rugged working chain is available in a pitch selection of 5.000 to 8.000 inches. Each hyperlink is produced in accordance with manufacturer’s standards and may be interchanged with links created by additional chain manufacturers. “H”CLASS Refuse Drag Chain is available in riveted construction just. Grease chambers, cored into each link’s barrel, hold grease which lubricates pins.
Wide faced sprockets, either of machined or cast steel, are recommended for”H” class Refuse Drag Chain operation. Links should be run in the direction of the closed barrel.